WARNING: Do not assemble, install, or operate this equipment without reading ALL of this manual and the safety precautions and warnings illustrated in
Operation KDAR Company Controls—Front 1. Power Switch 2. Power on indicator light—green light will illumi-nate whenever power is on. 3. Gas Pressu
Operation KDAR Company Operational Controls The PL-40 Plasma Cutter has the following con-trols: On/Off Power Switch Output Current Control
Operation KDAR Company Job Setup and Control Settings Make sure you are familiar with and follow all safety precautions prior to beginning work. P
Operation KDAR Company Cutting Note: Read all instructions prior to beginning cut-ting operations. 1. To begin cutting, place the tip of the torch
Maintenance KDAR Company Electric Shock Can Kill Only qualified personnel should attempt to install this equipment. Turn off the input power at
Maintenance KDAR Company Checking and Replacing Outside Nozzle, Tip, Air Diffuser and Electrode 1. Torch Handle/ Complete Hose Part # 23218 2. Sh
Troubleshooting KDAR Company 14 Warning Service and repair of the PL-40 should only be performed by a qualified technician. Unauthorized repairs or r
KDAR Company Troubleshooting 15 Pilot arc does not transfer to work The Thermal LED is lit Air flow LED is lit 1. Make sure there is a good
KDAR Company Warranty 16 KDAR Company, and its affiliates, warrants that all plasma cutters covered under this warranty is free from defects in materi
Additional Hot Max Products KDAR Company 17 Model 125WFG 125 Amp Wire Feed MIG Welder Model 135WFG 135 Amp Wire Feed MIG Welder Model 175WFG 175 Amp
OPERATOR’S MANUAL Model PL-40 Plasma Cutter TABLE OF CONTENTS Safety Symbols & Precautions 1 Specifications
KDAR Company 18 Additional Hot Max Products Model 500G Propane Torch Model WC100 Welding/ Plasma Cutter Cart Model VTK-MD Medium Duty Victor ® Sty
KDAR Company SAFETY PRECAUTIONS AND WARNINGS PLEASE READ BEFORE USING EQUIPMENT Keep children away from this equipment Protect your self and oth
CUTTING SPARKS CAN CAUSE INJURY, FIRE, OR EXPLOSION Remove all flammable materials from the plasma cutting and gouging area Always have a charge
NOISE CAN DAMAGE HEARING Prolonged noise exposure from cutting and welding equipment can cause damage if levels of noise exceed the OSHA standards
Specifications Description Unit of Measure Value Power Source Volts Single Phase AC110/220 (50~60HZ) Open Circuit Voltage Volts 310-405 Rated We
Installation/Setup Warning Safety Considerations Electric Shock Can Kill Only qualified personnel should attempt to install this equipment. Turn
Note: A pressure regulator must be used with nitrogen gas from a cylinder. The pressure from the nitrogen gas cylinder to the PL-40 should neve
Operation KDAR Company Safety Considerations Warning Electric Shock Can Kill Do not touch live electrical parts of the electrode with skin or wet
Comments to this Manuals