Hot-max-torches WP201 User Manual

Operator’s Manual Water Pumps WP201, WP30, WP40 WARNING: Do not assemble, install or operate this equipment without reading ALL of this manual and the

KDAR Company 9 Operation Starting the Engine 1. Move the fuel valve lever to the on position. 2. If the engine is cold at start, move the choke lev

KDAR Company 10 Operation Shutting Down the Pump Note: For emergency engine stop, simply turn the engine switch to OFF. 1. Move the throttle lever

KDAR Company 11 Maintenance REGULAR SERVICE PERIOD(3) ITEM Perform at every indicated month or operating hour

KDAR Company 12 Maintenance Engine Oil Change 1. Change oil while engine is warm to assure complete and rapid draining. 2. The Water Pump should be

KDAR Company 13 Maintenance Spark Plug Service Recommended Spark Plug: BPR6ES (NGK) W20EPR-U (DENSO) To insure proper engine operation, the spar

KDAR Company 14 Storage Note: Proper storage preparation is essential to keeping the pump trouble free. Following the steps below will keep the pump

KDAR Company 15 Storage Internal Oiling 1. Remove the spark plug. 2. Pour 1 tablespoon of clean engine oil into the cylinder. 3. Crank the engine

KDAR Company 16 Trouble Shooting Engine Will Not Start Refill the tank. NO Is there fuel in the tank? Is there oil in the engine? Add the recommende

KDAR Company 17 Trouble Shooting Engine Lacks Power Is the air filter element clogged? Is the fuel bad? Engine stored with-out treating the fuel or r

KDAR Company 18 Trouble Shooting Low Pump Output Is the suction hose collapsed, dam-aged, too long or too small a diam-eter? Is there an air leak at

KDAR Company 1 SAFETY PRECAUTIONS AND WARNINGS PLEASE READ BEFORE USING EQUIPMENT DANGER DANGER indicates a potentially hazardous situation which, i

KDAR Company Warranty KDAR Company, and its affiliates, warrants that the water pumps covered under this warranty are free from defects in material an

KDAR Company 2 SAFETY PRECAUTIONS AND WARNINGS PLEASE READ BEFORE USING EQUIPMENT 12. Always store the water pump in a well ventilated area. Follow t

KDAR Company 3 Specifications WP201 WP30 WP40 Engine Engine Type 4-Stroke, Overhead Valve, Single Cylinder 4-Stroke, Overhead Valve, Sing

KDAR Company 4 Features/Package Contents WP201  All Aluminum Pump Hous-ing w/Ceramic Seals  2” Suction & 2” Discharge Fittings  8700 GPM

KDAR Company 5 Component & Control Locations Fuel Tank Choke Throttle Fuel Valve Starter Grip ON/OFF Switch Oil Fill Cap & Dipstick Fuel Leve

KDAR Company 6 Set Up Engine Preparation Engine Oil NOTE: Engine oil is a major factor affecting the performance and service life of this water pump.

KDAR Company 7 Operation Pre-Start Preparation NOTE: The following procedures are to be completed each time the water pump is started. General Condi

KDAR Company 8 Operation Suction Hose Installation Note: Use commercially available suction hose that is reinforced with non-collapsible wall or brai